GENERAL FEATURES

• 5 W (136-174 MHz) Models • 5 W (400-470 MHz) Models • Meets ETSI EN Standards • 64 CH-GID / 4 Zones • Transmit / Busy / Call Alert / Warn LED • On / Off Volume Knob • 16-Position Mechanical Selector • 2 Side PF Keys • Emergency / AUX Key • 500 mW Speaker Audio • Emergency Call Features • Lone Worker • KMC-47GPS Speaker Mic Option • KPG-111D Windows® FPU*1 • Flash Firmware Upgrading • MIL-STD-810 C/D/E/F/G • IP54/55 Water & Dust Intrusion • PC Serial Interface • VGS-1 Voice Guide / GPS Data Storage Option • Transparent Data Mode*2

DIGITAL – GENERAL

• NXDN® Digital Air Interface • AMBE+2™ VOCODER • 6.25 & 12.5 kHz Channels • Over-the-Air Alias (TX) • Emergency Call • All Group Call • Status Messaging*2 *3 • Remote Stun / Kill*2 • Remote Check*2 • Short & Long Data Messages*2 • GPS Location with Voice*2 • NXDN® Scrambler Included

DIGITAL – CONVENTIONAL MODE

• 64 Radio Access Numbers (RAN) • Individual & Group Selective Call*4 • Mixed FM / Digital Operation • Conventional IP Networks • Site Roaming

DIGITAL – TRUNKING MODE

• Individual Private Call (RX / Talkback only) • Group Call & Broadcast Call • Transmission Trunked Mode*5 • Message Trunked Mode*5 • Call Queuing with Priority*5 • Late Entry (UID & GID)*5 • 4 Priority Monitor ID’s*5 • Remote Group Add*2 • Failsoft Mode

MULTI-SITE IP NETWORK COMPATIBLE

• 60,000 GIDs / UIDs • Wide Area Group Call • Auto Roaming Registration • Group Registration 

SCAN

• Single / Multi-Zone Scan / List Scan • Dual Priority Scan (Conventional)

FM MODES – GENERAL

• 25, 20 & 12.5 kHz Channels • FleetSync® / II*4 • DTMF Encode / Decode*4 • Voice Inversion Scrambler • Analogue Scrambler Board Capability

FM CONVENTIONAL ZONES

• QT / DQT / Two-Tone*3 • 5-Tone Encode / Decode*3 • Call Key 1-6 • Voting

FM LTR® TRUNKED ZONES

• Kenwood LTR® Features 

FleetSync® / II (FM)*4

• PTT ID Digital ANI • Selective Call & Group Call*4 • Status Messaging*2 *3 • Emergency Status • Short Text Messages*2

MDC-1200

• PTT ID Digital ANI • Caller ID Display • Emergency Status • Radio Check • Radio Inhibit

*1 The KPG-111D must be version 2.00 or later. *2 Requires NX subscriber unit PC Serial Interface compatible software application (e.g Kenwood AVL & Dispatch Messaging software) or hardware (e.g. console). *3 Pre-programmed key operation *4 Some screen/key-based functions are not available on the NX-200S/300S. *5 These trunked features are primarily system programming and operational dependent. Priority monitor also requires NX subscriber settings.

Back Back to top